Road friends equipment to tell you about the use of gantry scissors when what is easy to be omitted taboo

Overload: it is strictly prohibited to overload operation during use to reduce the number of maintenance and extend the life of the whole machine ‌.

‌Overload use ‌ : shall not exceed the design load of the equipment, strictly control the size of the cut and other elements, otherwise it may cause damage to the machine and equipment or personal injury ‌.

‌ over length and over width ‌ : it is forbidden to use shearing machine over length and over width, and it is not allowed to use shearing machine to cut quenched steel, cast iron and other brittle materials ‌.

‌ two people at the same time ‌ : when more than two people operate at the same time, should set a person to drive, unified command, pay attention to coordination and cooperation, it is forbidden for two people to cut two materials at the same time on the same shear bed ‌.

‌ do not check the status of the equipment ‌ : before use, check whether the main fasteners of the equipment are loose, whether the control mechanism, clutch and brake are normal, and whether the safety protection device is in good condition ‌.

‌ without routine maintenance ‌ : after use, the mechanical tools should be wiped clean and coated with protective oil to avoid rust affecting its service life ‌.

‌ failure to follow safety procedures ‌ : When an exception occurs in the operation, it must be stopped immediately and reported ‌.

‌ The correct operation and maintenance method of gantry scissors ‌ :



‌ Check the equipment status ‌ : before use, check whether the incision blade is loose, and then start the oil pump for test run after confirming that it is safe. Observe whether the machine is free from load and has abnormal sound and stuck ‌.

‌ Adjust the position of the blade ‌ : when cutting the steel bar, ensure that the blade edge is in the horizontal state and make corresponding adjustments to align it with the cutting object to ensure the cutting accuracy and reduce the damage rate ‌.

‌ Cleaning up the site ‌ : clean up the broken steel pan on the ground in time to prevent injury, and pay attention to the splashing iron scraps to avoid feet ‌.

‌ regular maintenance ‌ : regular inspection and maintenance of machinery and equipment to ensure the safety and reliability of production ‌.

‌ Observe safety procedures ‌ wear labor protective equipment correctly and check that clutches, brakes, transmission and other protective devices are intact ‌.

Through the above summary of road friends, coupled with complying with these taboo operations and correct operation and maintenance methods, not only can ensure personal safety but also ensure the normal operation and service life of road equipment.